Hydraulic Press (H / C Type)
Ram travel repeatable within +0.03mm or -0.03mm for consistent bends for interchangeable output. Ram travel is referenced from bed to avoid side frame deflection affecting stroke accuracy.
Rugged structure from ultra tested IS 2062 plates, rigidity conforming to international standards. Hydraulic, electricals of internationally reputed brands for consistent performance and reliable operation. Front operated manually back gauge front sheet supports with scale. Most hydraulic parts rated for 310 bar but working pressure only 160bar for long life, reliable operation.
Ram guides of 4-piece design with replaceable liners. Pivots with permanently lubricated by a central hand pump. Cylinders of ultra-tested seamless honed tubes, hard chrome-plated pistons, dual seals (Teflon ring plus set of chevron packings) for extra reliability. 3-speed bending cycles for faster output yet slow smooth bending with minimal shock loads. Movable control station with majority controls, emergency stop, up-down foot-switch controls, inch cycle mode for set-up and one-off jobs. Single-cycle modes for repeat cycles, production runs.
Main cylinder seals can be easily replaced without requiring a crane for dismantling the ram. Hydraulic power gives silent working, better safety against overload, instant stoppage-reversal of ram One set of unhanded standard punch, multi-V die Block Lifting chains system and rotation of die block when using multi-vee die block.